Spin and Serves

How to Handle Spin in Table Tennis: Racket Angle and Sidespin

How to handle spin in table tennis: set your racket angle for topspin and backspin, counter sidespin, adjust for heavy spin, and train with simple drills.

On this page
  1. Why spin causes errors
  2. Racket angle explained
  3. The two levers: angle and stroke direction
  4. Handling topspin
  5. Handling backspin
  6. How to counter sidespin
  7. Adjusting for how much spin there is
  8. Unusual rubbers: pips and anti-spin
  9. Drills to tackle spin

Why spin causes errors

When the ball hits your racket, the rubber grips it. Any spin on the ball pushes it off your racket in a particular direction:

  • Topspin pushes it up.
  • Backspin pushes it down.
  • Sidespin pushes it sideways.

If your racket is set up as if there’s no spin, the ball goes where the spin sends it: into the net, off the end, or off the side. Handling spin mostly comes down to setting up your racket and stroke so that the spin’s push sends the ball where you want.

Racket angle explained

“Racket angle” usually means how far the hitting face is tilted forward or back:

  • Closed: the top edge tilts toward the net, so the face points somewhat down at the table.
  • Vertical (neutral): the face points straight at the net.
  • Open: the top edge tilts back, so the face points somewhat up.

There’s also a sideways angle, which means turning the face slightly left or right. That’s mainly used against sidespin.

A rough guide:

Incoming ball Starting racket angle
Heavy topspin Clearly closed
Light topspin Slightly closed
No spin Near vertical
Light backspin Slightly open
Heavy backspin Clearly open

These are starting points. The right angle also depends on the ball’s speed and height and on your stroke, which is covered below.

The two levers: angle and stroke direction

You have two ways to deal with spin, and you’ll usually combine them:

  1. Racket angle, the tilt of the face.
  2. Stroke direction and force: whether you move the racket forward, upward or downward, and how hard.

For example, against backspin you can open the racket a lot and push gently forward, or keep the racket closer to vertical and brush strongly upward, as in a loop. Both lift the ball over the net. The second one adds your own topspin, which helps overpower the incoming backspin.

Handling topspin

Topspin wants to send the ball up and long off your racket.

  • Close the racket. The heavier the topspin, the more closed it needs to be.
  • Play forward and over the ball rather than upward.
  • Take it early, at or just after the top of the bounce, so the ball doesn’t drop and gain depth.
  • Block softly against very heavy, fast loops. Relax your grip and let the racket absorb some of the pace.

If your blocks fly off the end, close the racket more or soften your hands.

Handling backspin

Backspin wants to send the ball down off your racket.

  • Open the racket. Heavier backspin needs a more open face.
  • Lift, either by pushing forward and slightly upward, or by looping with a strong upward brush.
  • Get low. Bending your knees lets you brush up the back of the ball instead of reaching down at it.

If your pushes go into the net, open the racket more or add a little more forward and upward motion. If your loops against backspin go into the net, brush more upward and contact the ball slightly lower on its back.

How to counter sidespin

Sidespin is the spin most players find confusing, because it sends the ball sideways off your racket. A simple rule many coaches use: the ball comes off your racket in the same direction the opponent’s racket was moving when they contacted it.

So if your opponent’s racket swept from their right to their left, expect the ball to go toward their left (your right) off your racket.

There are three ways to counter it.

Aim against the drift

The simplest method is to aim toward the other side. If you expect the ball to drift to your right, aim further left than your real target. Many players also aim more toward the middle of the table, which leaves room for error.

You can also turn your racket face slightly, angling it against the drift, so the ball comes off straighter.

Contact the side of the ball

A more advanced method is to brush the side of the ball so your own sidespin cancels or redirects the incoming spin. It takes practice and good timing, but it gives you more control over direction.

Overpower it

Against long sidespin serves and balls you can attack, a strong topspin stroke into the middle of the table overrides much of the sidespin. The more spin you put on, the less the incoming spin matters.

Remember that most sidespin also carries some topspin or backspin. Adjust the forward or back tilt of your racket as well as the sideways angle.

Adjusting for how much spin there is

Reading the amount of spin matters as much as reading the type:

  • Heavy spin usually comes from a fast, thin brushing contact. The ball’s logo may blur, and it may curve or check noticeably.
  • Light spin often comes from a slower or thicker contact. You may see the ball’s markings rotating slowly.

Practical tips:

  • When in doubt, use more of your own spin rather than a flat hit.
  • Watch the opponent’s racket speed at contact. Fast usually means more spin, unless they’re faking.
  • Learn from misses. Into the net usually means more backspin (or less topspin) than you expected. Long usually means the opposite.

For serve-specific situations, see our guide on how to return a spin serve.

Unusual rubbers: pips and anti-spin

Not every opponent uses smooth (inverted) rubber, and the usual rules change when they don’t:

  • Short pips usually produce less spin and a flatter, more “knuckly” ball.
  • Long pips tend to return a version of the spin you put on the ball, often reversed relative to what you’d expect. If you loop into long pips, the return may come back with backspin.
  • Anti-spin rubber has a very low-friction surface and tends to deaden spin.

Against these rubbers, it helps to watch which side of the racket the opponent uses for each shot. Players are required to have different colours on each side partly for this reason.

Drills to tackle spin

  1. Push-to-loop. Your partner pushes backspin long. Practise looping with an upward brush, adjusting your racket angle until the ball clears the net consistently.
  2. Block heavy topspin. Your partner loops, and you block. Experiment with how closed your racket needs to be.
  3. Sidespin aim game. Your partner serves sidespin to the same spot. Try to return it to a target, adjusting your aim each time.
  4. Mixed-spin feed. Your partner or a table tennis robot mixes topspin, backspin and no-spin. Call out the spin before playing it.
  5. Shadow angles. Without a ball, practise setting closed, vertical and open angles quickly, so the adjustments become automatic.

For a full overview of the spins you’re dealing with, see our guide to the different spins in table tennis. And if you want to produce more spin yourself, read how to get crazy spin in ping pong.

The complete guide to spin and serves

Different Spins in Table Tennis: Topspin, Backspin and Sidespin
Read the guide

Keep exploring

Guides from other topics

All topics →