The short answer
In table tennis doubles, the serve must go diagonally from the server’s right half court to the receiver’s right half court. Partners then take turns hitting the ball. Each player serves two points in a row, as in singles. At each change of service, the player who was receiving becomes the server, and the partner of the previous server becomes the receiver. That gives a fixed four-player rotation that repeats through the game.
Below, the rotation is worked through with named players, along with how the order carries into later games, the switch at 5 points in the deciding game, and what happens when someone serves or receives out of turn.
The three rules that make doubles different
Doubles uses the same Laws as singles for scoring, lets, faults and the service action. Three things change:
- The serve is diagonal. In singles the serve can land anywhere on the receiver’s side. In doubles it must go right half court to right half court.
- Strokes alternate. The server serves, the receiver returns, then the server’s partner hits, then the receiver’s partner, and so on for the rest of the rally.
- The serving order rotates. All four players serve and receive in a set sequence, which is decided at the start of each game.
The diagonal serve
The table has a 3 mm white centre line running from end to end. It divides each side into a right half court and a left half court, seen from the player’s own end. A doubles serve must:
- bounce first in the server’s right half court, then
- pass over or around the net assembly, then
- bounce in the receiver’s right half court.
The centre line counts as part of each right half court, so a serve that lands on the line is good. A serve that lands in either left half is a fault, and the point goes to the receiving pair.
All the other service requirements still apply: the open-palm toss, the 16 cm minimum height, a ball that stays visible, and so on. In doubles, the ball also must not be hidden by the server’s partner. A doubles serve that clips the net and lands in the receiver’s right half court is a let, as in singles. See our guide to let rules for the other let situations.
Choosing the order at the start of the match
In the first game of a match:
- The pair that wins the toss chooses whether to serve or receive first, or which end to start at.
- The serving pair decides which partner will serve first.
- The receiving pair decides which partner will receive first.
Once those two choices are made, the rest of the order in that game is fixed.
How the serving order rotates
Say Pair A is Anna (A1) and Alex (A2), and Pair B is Ben (B1) and Bella (B2). Anna serves first and Ben receives first. The rotation runs like this:
| Rallies | Server | Receiver |
|---|---|---|
| 1–2 | A1 (Anna) | B1 (Ben) |
| 3–4 | B1 (Ben) | A2 (Alex) |
| 5–6 | A2 (Alex) | B2 (Bella) |
| 7–8 | B2 (Bella) | A1 (Anna) |
| 9–10 | A1 (Anna) | B1 (Ben) |
Rallies 9 and 10 repeat the start, and the cycle continues every eight rallies. Notice how each step follows the rule: Ben received from Anna, so Ben serves next, and he serves to Anna’s partner, Alex.
A simple way to remember it is that the ball goes in a circle. Each player always serves to the same opponent and receives from the other one. In this game, Anna serves to Ben and receives from Bella, every time.
Rotation at deuce
From 10-10, each player serves one point instead of two, but the rotation doesn’t change. If Alex served the rally that made it 10-10, the next serves go Bella to Anna, then Anna to Ben, then Ben to Alex, one point each, until one pair leads by two.
Serving order in later games
The pair that received first in one game serves first in the next. The new serving pair can choose which partner serves first, but the first receiver is then fixed: it’s the player who served to that server in the previous game.
Continuing the example, Pair B serves first in game 2:
- If Pair B chooses Bella to serve first, she must serve to the player who served to her in game 1. That was Alex. So game 2 starts Bella → Alex, then Alex → Ben, Ben → Anna, Anna → Bella.
- If Pair B chooses Ben, he serves to Anna (who served to him in game 1). The order becomes Ben → Anna, Anna → Bella, Bella → Alex, Alex → Ben.
Either way, every player now serves to the opponent they used to receive from. That’s the point of the rule: across a match, each player gets to serve to, and receive from, both opponents.
The deciding game: switching at 5 points
In the last possible game of a match (game 5 of a best of five, or game 7 of a best of seven), two things happen as soon as either pair reaches 5 points:
- The pairs change ends, as they would in singles.
- The pair due to receive next changes its receiving order.
Suppose the deciding game starts with the same order as game 1 above (Anna → Ben, Ben → Alex, Alex → Bella, Bella → Anna). The score reaches 5-3 after eight rallies, so the next serve is Anna’s. Pair B is due to receive, so Ben and Bella swap. Anna now serves to Bella instead of Ben, and the rotation becomes:
- Anna → Bella
- Bella → Alex
- Alex → Ben
- Ben → Anna
The 5-point mark can also come in the middle of a player’s two serves. The same rule applies: whichever pair is about to receive swaps. Without this switch, the same pairings would play out for the whole deciding game, which could favour one pair.
Alternating strokes during the rally
After the serve and return, partners must keep alternating: server, receiver, server’s partner, receiver’s partner, server, and so on. It doesn’t matter where the ball lands on the table or who is better placed. If the wrong partner hits the ball, that pair loses the point. Our guide to table tennis fouls covers this and the other ways to lose a rally.
The rules don’t say where partners must stand, only who hits next. That’s why doubles players move constantly. The player who has just hit usually steps out of the way, often backwards or to the side, to make room for their partner.
What if a pair serves or receives out of order?
Mistakes in the rotation are common, especially after a change of ends. If a player serves or receives out of turn, the umpire stops play as soon as the error is noticed. Play then resumes with the correct server and receiver at the current score. The correct order is the one set at the start of the match and, in doubles, by the serving pair’s choice of first server in the game where the error was found.
All points scored before the error was discovered still count. Nobody gets points back for rallies played in the wrong order. If the players forgot to change ends, the same principle applies: they switch ends at the current score, and the score stands.
Wheelchair doubles
The Laws relax the alternating-stroke rule for wheelchair doubles. The server must serve first and the receiver must return first, but after that either player of the pair may return the ball. A player’s wheelchair also mustn’t cross the imaginary extension of the centre line. Some wheelchair-specific service rules apply too, such as certain serves being a let when the receiver is in a wheelchair. Our guide to table tennis rules includes a section on Para table tennis.
Positioning and movement tips
These aren’t rules, but they help a doubles pair get through the rotation without colliding:
- Right-hander and left-hander pairs have the easiest time, because they naturally stand on opposite sides and can move in and out without crossing paths.
- Two right-handers usually move in a circular or in-and-out pattern: hit, then step back and to the side so the partner can come in.
- The receiver’s stance matters because every serve comes to the right half court. Many right-handed players receive with their forehand from near the centre line, or reach across for a backhand flick.
- Agree on serves in advance. Many pairs use hand signals under the table to tell each other what serve is coming. See table tennis hand signals for how doubles signals and umpire signals work.
Doubles rules FAQ
Do doubles partners have to switch sides?
No rule requires partners to stand on particular sides of the table. The rules only fix who hits the ball in which order. Players move around so the next hitter can reach the ball, and that movement can look like “switching sides.”
Does the serve have to be diagonal in singles?
No. The diagonal requirement applies only to doubles. In singles, a legal serve can land anywhere on the receiver’s side, including the sideline edge. Some casual players use a diagonal rule in singles as a house rule, but it isn’t part of the official rules.
Are there special rules for mixed doubles?
No. Mixed doubles uses exactly the same rules as men’s and women’s doubles.
How do you keep track of the order?
Remember who you serve to and who you receive from. Those stay the same for a whole game, apart from the receiving switch at 5 points in the deciding game. If you lose track, the scoring shortcut in our guide to reading table tennis scores tells you which pair is serving, and the rotation tells you which player.